New Version Metal Model XPROG-M V5.0

Introduction for XPROG-M

XPROG-M, with newest released software V5.0 version, full authorization, special designed to replace the earlier version of XPROG programmer and support more hardwares and softwares than before with more easy operating.

New Features of  XPROG-M

*Self checking

*on- board programming

*Absolutely compatible with all software versions of ” Device Programmer Desktop”

*Software update- directly from “Device Programmer Desktop” more easier and convenient

*With higher speed than former version

*Fully work with USB to RS232 adapter

*Two PWM regulated and ADC controlled voltage regulators

* high output current MPU

*read the eeprom chip

Device Supported

※TEXAS INSTRUMENTS TMS370

※TEXAS INSTRUMENTS TMS374

※MOTOROLA MC68HC05

※MOTOROLA MC68HC08

※MOTOROLA MC68HC11

※MOTOROLA MC68HC(S)12

※Eprom

Attention

Firstly, the newest version of this item is V5.0 it can not be updated, it will out of control after your updating Secondly, must work with XP computer system, other wise, you will come up with some fault! Thirdly, close the anti-virus software before installing.